|
|
|
Surface Temperature
Surface Thermometers, Surface Probes and Infrared Thermometers
PTC Metrology™ provides calibration and certification services for our bimetal surface thermometers, surface probes with readouts and non contact IR thermometers.
Many quality systems require that certified thermometers be used where precise measurements are of critical importance. PTC® has always offered temperature calibration and
certification traceable to NIST and is accredited by A2LA for temperature calibration.
Purchase Thermometers from PTC® Instruments
The scope of our accreditation can be down loaded by using the following link Accreditation and Scope.
Basic Certification: NIST Traceable (non A2LA) - without logged points
This certification is best for customer's needing only calibration traceability to NIST without the added cost of logging the calibration results, A2LA accredited certification or
meeting the requirements of ISO guide 17025. Although no specific points will be logged, UUT's referred to will be calibrated at three or more points over the UUT's range.
Up to five instruments of the same model and range can be listed on the certification for the basic price. Additional units above quantity of five can be added for a nominal fee.
This certification will not list any adjustments or out of tolerance conditions and only applies to bimetal surface thermometers manufactured by PTC Instruments.
Series 310, 314, 484, 486, 570 and 675. Price $80.00
A2LA Certification: NIST Traceable 3 Logged Temperature Points
This certification will contain the as before and after calibration results of the UUT at the 3 temperature readings across the UUT's full scale. In addition to the readings,
certification will include laboratory conditions, information on the primary standards and a statement of uncertainty. Price $135.00
Customer's Specified Temperature Points: (A2LA Accredited Certification)
This certification will contain the as before and after calibration results of the UUT at the point(s) selected by the customer. The points may be selected from the chart below.
In addition to the readings, certification will include laboratory conditions, information on the primary standards and a statement of uncertainty. Cost of the certification will
depend on which temperature points the customer chooses. To assist you in selecting temperature points, please refer to ASTME-77 and NIST recommendations.
*Please note that certification prices do not include any labor, adjustments, repairs or parts.
NIST/A2LA (ISO 17025)Accredited Certification (Customer's choice of points) Minimum fee $95.00
Temperature Range
|
Price Per Point
|
-5C to 23C
|
$80.00
|
23C to 100C
|
$65.00
|
100C to 200C
|
$75.00
|
200C to 300C
|
$80.00
|
300C to 400C
|
$85.00
|
400C to 525C
|
$95.00
|
To order customer selected points, please call customer service 877.782.2329
Recall Notification
PTC Metrology™ will notify you by email when your instrument is due for recalibration, in accordance with the period of validity that your quality system specifies.
Please register your instrument today.
Contact us | View site map
|
|
|
|